ION RC - Printed Battery Tray - Neon Yellow - SAB Goblin Raw 420

• We manufacture all of our printed products right here at our facility in Amery, Wisconsin USA, using some of the highest quality printers on the market.
• All our printed products also use the highest quality filaments from an American owned and operated manufacturer, they only use American made raw materials.
• We are proud to say that every one of our printed products, from raw material, to the finished product, even the plastic bags, and folded card stapled to the top of the parts bag is made in the USA!

Battery Tray Features:

As you can see, we made a few design changes from the stock tray:

• First, we started with angled battery strap slots that will accept up to a 25mm wide heavy duty strap, these slots will keep your straps in place when changing batts on the tray, and they also keep the straps from sliding, or wiggling off the ends of the tray. Click here for straps we found to be a great fit for these trays and most common battery sizes you could fit on the tray. Most straps between 400mm and 430mm will work for most batteries.
• Then we elongated the pin slide angle at the top right, this allows the pin to slide more smoothly as you push the tray up to snap the pin into place. This is easier on the pin, the pin mechanism, the tray, and you!
• We also designed the tray so once the pin does snap into place, there is nearly zero movement of the tray, this keeps vibrations & resonance down overall, keeping your battery from vibration, resonance, and shaking, can prolong its life, and will keep your RAW 420 running as smooth as possible, that can only be a good thing!
• This blended co-polyester that we use also helps protect your battery, since the tray can help take the brunt of a crash/impact.
• We elevated where you stick the battery down using velcro, or two sided tape by a little over 1mm, this helps with airflow around the bottom sides of the pack, which helps keep the battery cooler as we seen from testing against our other prototypes that did not have this raised area for added airflow.
• Oh, and it's made from a highly chemical resistant co-polyester polymer, you can get nitro fuel on it, gasoline, grease, etc.., We never use PLA for any parts that will be used outdoors, PLA is NOT for outdoor use and has almost no resistance to anything, including nitro fuel, most lubricants, and PLA will fade and breakdown simply by being in the sun's UV rays.
• NOTE, The ION rc RAW 420 Tray "does not" have mounting holes for the quick release system, as some of you find it better to connect by hand. Keep in mind, once the quick connectors are connected, the stock tray can slightly move/wiggle around with almost a 1 pound battery stuck to it while in flight making the two connectors move around causing inconsistent wear on the connectors bullets, and the housing. This is one of the reasons many pilots do not use the quick connect system.

Photo below is the bottom of the tray, photo above is the Top.

• The top of the tray has a 110mm long by 31mm wide area for battery mounting tape, velcro, etc.. Most of the double sided tape we use for our batteries is 30mm wide at most. You can also see the two 25mm wide battery strap slots, the slots are angled, making installing, and adjusting the straps very easy.
• Remember to clean the top of the tray with IPA and a lint free rag or towel to remove any dust, or oils that might be on the tray before sticking anything to it. Once clean we suggest letting the tray sit for 5 minutes or so to make sure the IPA has evaporated from the part completely(or a little quicker if you point a fan at it).