Loading... Please wait...


Our Newsletter

Scorpion HK and HKIII 4025 Motor Shaft Kit - 6mm Pinion Shaft

  • Image 1
Usually ships within 24hrs
Calculated at checkout

Product Description

 Scorpion HK and HKIII 4025 Motor Shaft Kit - with 6mm x 30mm Pinion Shaft

  • Pinion area of shaft sticks out of motor approximately 30mm
  • Total (end to end) Shaft length is about 84mm.


The Scorpion HK-4025 & HKIII-4025 motors are built with 8mm hardened steel shafts that will last through countless hours of flying fun, but occasionally, on a "Less than Perfect" landing, you may bend or break one. For these occasions, we offer factory replacement shafts for all the HK-4025 & HKIII-4025 series Scorpion Helicopter Motors.

The shaft for the HK-4025 & HKIII-4025 series motors measures 8mm in diameter, and is 83.7mm long. The Stock HK-4025 & HKIII-4025 motors have a 6mm output shaft end on them to allow the user to install 6mm pinion gears. This shaft kit is designed with a 6mm output end for those helicopters that have the stock pinion gears with a 6mm inner bore. The shaft kit will also fit other brushless motors that require an 8mm shaft of this length with a 6mm end. The shafts can be cut shorter with a Dremel tool and a cut-off wheel if necessary to fit other motors.

Note: The shafts in the Scorpion motors are a slight press fit into the aluminum front housing. The shafts will not just slide out when the setscrews are removed. They need to be pressed out in a bearing press, or in a drill press, with the front housing of the motor supported in a block of wood to prevent warping the front housing.



- HKIII-4025 Motor Shaft (6mm x 30mm) x1
- Washer x 1
- C-Clip x 2


Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the Scorpion HK and HKIII 4025 Motor Shaft Kit - 6mm Pinion Shaft to your wish list.

SSL Secure by GeoTrust